do You have some information how to repair anker soundcore pro cause the devices can not be charging.

need some tools how to open and battery replacement.

thanks

⟐ Answered January 08, 2024 at 2:28 MST

These are the pieces I found inside the speaker but can't figure out how to fix it.

Any suggestion would be a great help.TIA

⟐ Commented January 24, 2025 at 11:46 MST

It's not turning on even if I kept it on the charger for one day

⟐ Answer edited January 24, 2023 at 16:59 MST

I have tried to turn the device on with the power button, it will not turn on.

Red light shows up when the power is plugged in but that does nothing.

I opened the unit up and took the battery out, the battery was reading 3.2mah

⟐ Answered December 29, 2022 at 13:56 MST

The front of the Anker Soundcore Sport XL is different. It seems like there are allen screws in them, but I can’t tell if they’re for show. No standard allen key seems to work.

Does anyone know how to disassemble the Anker Soundcore Sport XL to replace the micro USB port? Will the guide below be similar steps after removing the front?

ANKER SoundCore Charging Port Replacement

⟐ Commented July 12, 2024 at 12:00 MST

The thing is, there is no obvious hole or secret thing to be screwed out or peeled off to get it opened, unless it requires peeling off the whole rubber skin of its bottom/feet..

I found this site which looks at its disassembled parts, but it's just that: already disassembled parts. The holes there suggests maybe screws, but...this speaker seems closed shut.

I tried opening it with the iFixit Pro tools I have, but to no avail.

...Maybe I have to pry harder? I might be fighting my way through adhesives here.

⟐ Answered November 23, 2024 at 6:12 MST

⟐ Commented August 22, 2019 at 2:28 MST

I have bluetooth speaker which is charger using à mini USB port. The USB plug has been destroyed and is no longer usable. Taling the speaker apart I can see where the battery attaches to the PC board. If I 'tap in' to the wires going from the battery to the board and attach a 5V 1A power source, everything seems to work OK. Also, it appears as though the battery charges up.

I could simply cut the battery wires and run the speaker directly from the power block. The question is, if I keep the battery connected will it overcharge and cause problems (such as overheating and catching fire)?

Thanks.

⟐ Answer unaccepted March 19, 2018 at 17:37 MST

⟐ Answered November 23, 2024 at 6:19 MST

⟐ Answered October 02, 2023 at 2:17 MST

⟐ Answered October 29, 2022 at 18:10 MST

⟐ Answered September 21, 2021 at 0:05 MST

Whole house smells like plastic

⟐ Answered September 16, 2019 at 10:11 MST

⟐ Answered March 27, 2019 at 15:14 MST

I need a repair manual with a how to plan

⟐ Commented August 14, 2025 at 15:21 MST

⟐ Edited February 11, 2025 at 11:48 MST

It gives off that offensive feeling of blowing very strong wind on a water proof, like buzzing & rattling while i play any song, the right passive radiator plays just fine, i have reset Bluetooth, speaker itself, changed phone & connecting distance too, i have examined for air leakage by pressing one of the passive radiator inside, the other corresponded just fine, my guess is a hardware issue then, a faulty passive radiator

Is it possible to fix or change a faulty passive radiator as i haven't seen any video, pics or instructions about it, if it's possible, how do i go about it

Thanks!