iDea USA CT702 Microphone Replacement
Benton Gray and 5 other contributors
Last updated on May 7, 2024
Views: 470
View statistics:
- Past 24 Hours:
- 1
- Past 7 Days:
- 19
- Past 30 Days:
- 94
- All Time:
- 470
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 0 1
No one has marked this guide "completed." Will you be the first?
1 person has marked this guide "completed." It's you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Slice and Dice
The steps in this guide should be split up and made into a series of prerequisite guides.
Introduction
Go to step 1 ↓Plug your soldering iron in on the highest setting for later steps. This is a easy to intermediate level guide that requires a knowledge of soldering.
What you need
-
-
-
Use a fingernail, or a plastic opening tool to gently pry the black panel around the portholes.
-
-
-
Use your fingers to pry the rest of the back off; slowly apply pressure from each side to break each clip connection.
-
-
-
Once the back is off, position the tablet as shown and be sure to warm your soldering iron.
-
-
-
Tool used on this step:Tweezers$4.99
-
Grip the new microphone with tweezers and place in the slot.
-
Solder the new connections while using tweezers to hold the speaker steady.
-
Ask FixBot
To reassemble your device, follow these instructions in reverse order.
Team
Colorado Springs, Team 4-7, Panko Spring 2015 Member of Colorado Springs, Team 4-7, Panko Spring 2015
UCCS-PANKO-S15S4G7
3 Members
60 Guides authored
