What you need
-
-
To remove the lens, three T15 x 12.5mm screws must be removed by a T15 head screwdriver.
-
The location of the other two screws are marked in red.
Ask FixBot
-
-
-
After the lens has been removed the back cover needs to be removed. There are no snaps or screws holding it in place.
-
-
-
-
Remove the circuit board by pressing on the mounting clips (shown in red circles) using the spudger.
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Team
IUPUI, Team S2-G3, Harley Fall 2017 Member of IUPUI, Team S2-G3, Harley Fall 2017
IUPUI-HARLEY-F17S2G3
3 Members
6 Guides authored
