XtremeMac Luna Dissasembly - iFixit Repair Guide

Free Shipping on Domestic Orders $75+

Introduction

This guide will show you how to open the XtremeMac Luna so that its inner components are easily accessible.

What you need

1. Step 1 Bottom Panel
  Flip the device over so that the batteries are closest to you.
  
  Remove the battery lid by pressing the battery cover's tab and pulling it away from the device.
  
  Push the battery against the spring and lift it out of the casing.
  
  Repeat with the other battery.
  Edit
  
  Ask FixBot
  
  Add Comment
  
  1024
3. Step 2
  Unscrew all eight 12mm Phillips head screws with a Philips #1 screwdriver.
  
  The iFixit 26 bit screwdriver kit will not reach the screws. Make sure to use a screwdriver that is thin enough to not get stuck in the screw holes.
  Edit
  
  Ask FixBot
  
  Add Comment
  
  1024
4. Step 3
  Flip the Luna back over so that the buttons are facing upward and the LCD screen is facing you.
  
  Gently tilt the lid back 45 degrees so that the inside is exposed.
  
  Be mindful of the wires inside of the Luna. It is easy to break a connection if a wire gets caught.
  Edit
  
  Ask FixBot
  
  Add Comment
  
  1024

Conclusion

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

with 6 other contributors

Daniel Johnson

Member since: 04/14/13

1 Reputation

1 Guide authored

Team

Cal Poly, Team 3-47, Amido Spring 2013 Member of Cal Poly, Team 3-47, Amido Spring 2013

CPSU-AMIDO-S13S3G47

4 Members

96 Guides authored

0 Guide Comments

View Statistics:

Past 24 Hours: 0

Past 7 Days: 4

Past 30 Days: 21

All Time: 732