Introduction
In this replacement guide, step by step instructions will show how to replace the circuit board located inside of the Vornado Duo.
What you need
-
-
-
Start off by using a Philips #2 screwdriver to remove all 8 10mm exterior screws on the rear of the device.
Ask FixBot
-
-
-
-
Remove fan blade after unscrewing top 2 screws located on each side of the covered board.
-
-
-
Unsolder the circled spots on the mother board and resolder each wire to corresponding spot.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Team
USF Tampa, Team S1-G1, Nance Fall 2017 Member of USF Tampa, Team S1-G1, Nance Fall 2017
USFT-NANCE-F17S1G1
3 Members
16 Guides authored
