Introduction
Device model: Volisun 4-inch recessed LED light.
What this guide does: Replace a burned or degraded 4-inch VOLISUN recessed LED light (also known as a pot light). By completing the steps of the guide, you will have a new working LED light.
About the part: The LED connects to a small driver box(power box) that is above the ceiling. This guide only replaces the LED light.
When to use the guide: Use the guide when the LED light won't turn on or is physically damaged. If you have a similar light, make sure it's LED-compatible before replacing.
What you need
-
-
-
Find where the clips are for your LED light by pulling carefully.
-
Carefully pull down from one side where the clip is.
-
Press down the clip to not damage part of the ceiling.
-
Pull towards you so the other clips comes out.
-
-
-
Twist the cap counterclockwise.
-
Pull the cap up.
-
Disconnect the LED connector from the driver connection.
-
-
-
-
Attach the new LED light connector to the driver connection.
-
Put the cap back.
-
Twist in a clockwise direction.
-
-
-
Push both sides of the clips towards the middle.
-
Push up until the clips are inside the hole.
-
Push until it's flush with the ceiling.
-
Ask FixBot
Cancel: I did not complete this guide.
2 other people completed this guide.
Team
Austin Community College, Team 1-10, Bray Fall 2025 Member of Austin Community College, Team 1-10, Bray Fall 2025
AUSTINCC-BRAY-F25S1G10
1 Member
12 Guides authored
