Introduction
If your watch will not turn on there is a chance that your master switch is stuck or not functioning properly. The following guide will show you how to replace one of the most essential buttons on the Vtech Kidizoom Smart Watch DX.
What you need
-
-
Next, use the Phillips #00 screwdriver to unscrew the four 6.0 mm screws located in each corner of the watch to remove the backplate.
-
-
-
-
After removing the backplate, lift the master switch up from the circuit board.
-
Ask FixBot
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Team
UMass Dartmouth, Team S3-G5, Peak Fall 2018 Member of UMass Dartmouth, Team S3-G5, Peak Fall 2018
UMASSD-PEAK-F18S3G5
4 Members
7 Guides authored
