Introduction
Use this guide will show how to replace the USB cable.
Please note that this guide requires soldering. For more information on how to solder and desolder connections, please visit this guide.
What you need
-
-
Remove the two 10mm black screws on the top of device using a Hex 2.5mm Key. Only the two outside screws.
-
Gently pull apart both halves of device to access inside.
-
-
-
-
Using a small plastic opening tool, gently pry up the white connector that connects the USB cable to the board.
-
Ask FixBot
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Team
USF Tampa, Team S1-G33, Cagle Fall 2017 Member of USF Tampa, Team S1-G33, Cagle Fall 2017
USFT-CAGLE-F17S1G33
4 Members
5 Guides authored
7 Guide Comments
kunt u mij vertellen waar ik het kabeltje kan kopen?
Rene
Then wat where do u get usb cord to replace it some one plz explian
Oh man.. the first comment about this was 2019 and we both are still waiting for an answer huh
