Sony SRS-X55 Input Board Replacement
Chris Sparzo and 5 other contributors
Last updated on May 7, 2024
Views: 1.6K
View statistics:
- Past 24 Hours:
- 4
- Past 7 Days:
- 17
- Past 30 Days:
- 82
- All Time:
- 1,597
Comments: 5
3 comments on steps, 2 guide comments.
Go to guide commentsCompleted: 0 1
No one has marked this guide "completed." Will you be the first?
1 person has marked this guide "completed." It's you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Introduction
Go to step 1 ↓This guide is a walk through for how to remove and replace the input board for the Sony SRS-X55 speaker.
What you need
Tools
-
-
Spudger4.9
-
-
-
Locate the six 9 mm screws on the bottom of the SRS-X55 and remove them using a Phillips head #2 screwdriver.
Ask FixBot
-
-
-
Insert a plastic spudger at the seam of the bottom panel and remove it from the rest of the speaker.
-
-
Tool used on this step:Tweezers$4.99
-
Locate the battery plug and remove it using a pair of tweezers.
-
-
-
Locate the two 3.5 mm screws on the bottom of the I/O board and remove them using a Phillips head #2 screwdriver.
-
-
-
Insert a plastic spudger into the seam of the metal speaker cover and pry it downward until it releases from the speaker body.
-
-
-
Locate the eight 8.9 mm screws on the face of the speaker assembly and remove them using a Phillips head #2 screwdriver.
-
-
-
Insert a plastic spudger underneath one of the tabs located on the front of the speaker assembly and gently raise the speaker assembly above the rest of the speaker.
-
-
-
Locate the two wire connections as shown underneath of the speaker assembly and unplug them using a pair of tweezers.
-
-
-
-
Locate the wire connecting the motherboard and the input board under the top panel of the speaker and remove it using a pair of tweezers.
-
-
-
Insert a plastic spudger into the seam at the edge of the top panel and gently pry it away from the rest of the speaker.
-
The spudger can be inserted laterally into the opening created by the spudger and slid along the top as shown to remove the panel in a single motion.
-
-
-
Locate the three 4.5 mm screws on top of the speaker input board and remove them using a Phillips head #2 screwdriver.
-
-
-
Insert a plastic spudger underneath the edge of the input board and gently pry it away from the rest of the speaker.
-
-
To reassemble your device, follow these instructions in reverse order.
Team
IUPUI, Team 2-3, Baechle Spring 2017 Member of IUPUI, Team 2-3, Baechle Spring 2017
IUPUI-BAECHLE-S17S2G3
3 Members
36 Guides authored
