Introduction
In this guide, the camera will be disassembled and the button board will be removed and replaced. In order to reach this part of the camera, you have to disassemble the back panel.
What you need
-
-
-
-
Remove the six 3.5mm Phillips #000 screws.
-
Rotate the lock away from the camera.
-
-
-
Remove the two plastic spacers between the front and the back panels.
-
Carefully remove the back panel.
-
-
-
-
-
Disconnect the no-fuss ribbon cable by gently pulling it out of the button board.
-
Ask FixBot
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
USF Tampa, Team 17-1, Blackwell Fall 2016 Member of USF Tampa, Team 17-1, Blackwell Fall 2016
USFT-BLACKWELL-F16S17G1
4 Members
72 Guides authored
