Single-Speed Bicycle Chain Replacement
SaniaHey and 3 other contributors
Last updated on May 14, 2024
Views: 4.9K
View statistics:
- Past 24 Hours:
- 11
- Past 7 Days:
- 78
- Past 30 Days:
- 282
- All Time:
- 4,875
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 1 2
1 person has marked this guide "completed." Will you be next?
2 people have marked this guide "completed." Including you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Featured Student Guide
This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.
Introduction
Go to step 1 ↓This guide demonstrates how to replace the single-speed chain on the Bambike Mira Nila Bolt, which is famous among users for its comfort and looks.
Since this bike model can't switch gears, the chain is considered a single-speed chain. This chain makes it possible for the pedals to move the bike wheels.
Replacing the chain is important because a worn-out chain can cause damage to other vital parts of the bike. A chain can even fall off if it isn't replaced in time. If you replace your chain, you not only prolong the life of your bike, but you also ensure your safety while riding.
Please note that this repair can become messy when touching various bike parts.
What you need
-
-
-
Use either an Allen or crescent wrench to loosen the nuts of the rear wheel of the bike. Make sure to do this on both sides of the wheel.
-
-
-
Place the chain breaker tool over the old chain.
-
Insert a link of the old chain into the chain breaker tool.
-
-
-
Turn the knob on the chain breaker tool until the pin within the chain has popped out.
-
Remove the old chain.
-
-
-
Unbox the new chain and place it on the chain ring.
-
Align the rings with the gears to ensure a proper fit.
-
-
-
Wrap the chain around the cog of the rear wheel and bring the two ends of the chain together.
-
Remove the excess chain using the chain breaker tool. Refer to steps 3 and 4 for how to use the chain breaker tool.
-
-
-
Locate the master link of the chain.
-
Insert the link pins into the two ends of the chain.
-
-
-
-
Once the chain is on, pull the rear wheel back.
-
Tighten the nut on the drive side (right side) of the rear wheel.
-
-
-
Push the front end of the rear wheel to the non-drive side (left side) of the wheel. This pulls on the chain, creating tension.
-
Tighten the nut on the non-drive side (left side) of the wheel.
-
-
-
Repeat the previous step with the drive side (right side) until the wheel is tightened.
-
Ask FixBot
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
UC Davis, Team 1-7, Andersen Winter 2024 Member of UC Davis, Team 1-7, Andersen Winter 2024
UCD-ANDERSEN-W24S1G7
3 Members
12 Guides authored
