Introduction
Before beginning this guide, ensure that the device is both unplugged and cool; failure to do so may result in electrocution or burns.
What you need
-
-
-
Use the Philips head #0 screwdriver to remove the two 11.49mm screws at the back of the iron.
-
Remove the back cover piece.
Ask FixBot
-
-
-
Use the Philips head #0 screwdriver to remove the two 11.77mm screws holding the white clamp to the iron.
-
Use the Philips head #0 screwdriver to remove the two 6.58mm screws holding the black wires to the body of the iron.
-
-
-
Pull the split end of the power cord upward through the ball joint of the iron.
-
Set aside the power cord.
-
-
-
-
Use the Philips head #0 screwdriver to remove remaining 6.58mm screws that hold a wire on the bottom (brown and blue).
-
Unscrew from left to right.
-
Unclip the black adapter piece on the bottom right.
-
-
-
Use the Philips head #0 screwdriver to remove two 9.75mm screws (left and right) affixed to circuit board.
-
-
-
Use the Philips head #0 screwdriver to remove the two 9.82mm screws (left and right) from the white border on top of the circuit board.
-
Pull the circuit board out from its affixed position.
-
-
-
Lift the handle and wiggle the plastic trim and the orange-chrome bezel out from under the handle.
-
Remove and set aside the mode display.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
