Introduction
Following this guide requires cutting wires and soldering. For more information on soldering visit the soldering guide.
What you need
-
-
-
Squeeze Dust Cup release buttons on either side of the component.
-
Pull up to release Dust Cup.
Ask FixBot
-
-
-
-
-
Remove the five 15 mm screws by twisting counterclockwise with a T10 Torx screwdriver.
-
-
-
-
Remove the two 15mm screws by twisting counterclockwise using the T10 Torx screwdriver.
-
-
-
Remove the two 15 mm screws by twisting counterclockwise with a T10 Torx screwdriver.
-
-
-
Remove the two 15 mm screws holding the motor cover by twisting counterclockwise with a T10 Torx screwdriver.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Team
Cal Poly, Team S17-G5, White Fall 2018 Member of Cal Poly, Team S17-G5, White Fall 2018
CPSU-WHITE-F18S17G5
4 Members
132 Guides authored
