Introduction
With this guide you can clean or repair a faulty keypad.
What you need
-
-
Remove the five screws with a size 00 screwdriver. There are 4 in the corners and one on the top as shown.
-
-
-
-
Be sure that all 5 screws are removed and start to carefully remove the back cover by using the iPod Opening Tool in the slots on the bottom of the device.
-
Some force must be applied, and the back cover should come off.
-
-
-
Use the Ipod Opening Tool to lift the green logic board carefully.
-
Remove the logic board from the device.
-
-
-
The keypad should peel off the logic board with a gentle pull.
-
Use a clean, soft, cotton cloth to gently remove any debris or liquid that may be located on the pad or logic board interface.
-
Ask FixBot
To reassemble your device, follow these instructions in reverse order.
Team
Cal Poly, Team 29-81, Johann Spring 2010 Member of Cal Poly, Team 29-81, Johann Spring 2010
CPSU-JOHANN-S10S29G81
4 Members
12 Guides authored
