-
-
-
Place the display panel against the front of the machine.
-
Route the wiring through the opening and make sure no cables get pinched.
-
Press the display panel into place until it sits flush against the housing.
-
Reinstall the screw at the lower-left side and tighten it.
Ask FixBot
-
-
-
-
Reconnect the display panel connectors.
-
Route the wiring back into its original position.
-
Check that all connectors are fully seated before continuing the assembly.
-
-
To reassemble the device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Special thanks to these translators:
100%
Manusje van Alles is helping us fix the world! Want to contribute?
Start translating ›
