Introduction
A defective drill trigger can unintentionally keep the drill on when used by operators and this safety hazard increases the chances of accidental punctures to nearby objects.
What you need
-
-
-
Eject the battery from the drill.
-
Unscrew the seven M3x15.3mm screws, with the 2mm hex screwdriver bit, that secures the Housing Assembly.
Ask FixBot
-
-
-
Push the metallic Housing Connecting clip out with flat side of the plastic spudger.
-
-
-
-
Motor Assembly/Gearbox and Trigger Switch removed from Housing Assembly.
-
Desolder the black wire connected to the motor.
-
Flip Trigger Switch and desolder red wire.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Team
USF Tampa, Team S1-G2, Leahy Spring 2019 Member of USF Tampa, Team S1-G2, Leahy Spring 2019
USFT-LEAHY-S19S1G2
4 Members
60 Guides authored
