Introduction
With this guide, you will be able to remove, replace, and/or change the position of the guard on your Ridgid Brushless R86040. You should replace the guard anytime it becomes bent or damaged as this is a safety hazard. Users may also wish to rotate the guard to its various positions for different cutting and grinding angles. Before you begin, make sure the power is off, the battery is not attached to the device, and the cutting blade has been removed.
-
-
Identify the silver lever behind by where the guard and blade are located.
Ask FixBot
-
-
-
-
While pressing the lever, spin the guard clockwise. The teeth holding it together will line up and the guard will detach from the rest of the device.
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Team
Embry-Riddle Aeronautical University, Team S22-G7, Branham Fall 2019 Member of Embry-Riddle Aeronautical University, Team S22-G7, Branham Fall 2019
ERAU-BRANHAM-F19S22G7
3 Members
2 Guides authored
