Introduction
In this guide, we will show you how to safely replace the left/right switches in your Razer Naga V2 Hyperspeed Wireless Mouse.
The left/right switches are the primary buttons, which are programmed by default to perform mouse actions. These are the main buttons for selecting and interacting with elements on a computer.
Common Cause
- Corrupted Drivers
- Low Battery
- Physical Debris
- Internal Hardware Failure
This guide will walk you through each step of fixing your left and right switches with each step of this replacement process. Please be careful and ensure you are patient with this process to avoid any damage to your device.
What you need
-
-
Take off the magnetic top with the iFixit Opening tool and remove the dongle.
Ask FixBot
-
-
-
Use a T6 Torx screwdriver to remove the four 1.7 mm-long screws on the bottom of the mouse.
-
-
-
-
Disconnect the brown ribbon cable that's connected to the scroll wheel with precision tweezers.
-
-
-
Use the iFixit Opening tool on the clip near the front of the mouse to release and remove the scroll wheel.
-
-
-
Remove all six 1.7 mm-long Phillips #1 screws securing the motherboard and top left panel.
-
-
-
Remove the motherboard and remove the left/right click switches using the precision tweezers.
-
To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.
Team
University of North Texas, Team 2-6, Harold Fall 2025 Member of University of North Texas, Team 2-6, Harold Fall 2025
UNT-HAROLD-F25S2G6
4 Members
6 Guides authored
