Protocol Videodrone AP Battery Wiring Replacement
Serge and 5 other contributors
Last updated on May 7, 2024
Views: 2.4K
View statistics:
- Past 24 Hours:
- 3
- Past 7 Days:
- 17
- Past 30 Days:
- 97
- All Time:
- 2,357
Comments: 3
3 guide comments.
Go to guide commentsCompleted: 1 2
1 person has marked this guide "completed." Will you be next?
2 people have marked this guide "completed." Including you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
Step Trimmer
This guide has unnecessary steps. Trim them to be more concise!
Introduction
Go to step 1 ↓This guide will show you how to replace the battery and the soldering new wires to the motherboard. This is guide includes a highly recommend soldering guide. CAUTION: Soldering iron will be hot and may cause minor burns if handles improperly.
What you need
Tools
-
-
-
Open the hatch and carefully pull out the battery to expose the cable connection
-
-
-
Unscrew the 4 screws from the bottom of the drone.
-
Unscrew the 8 screws connecting the propeller guards to the drone
-
Unscrew the four propeller screws.
-
-
Tool used on this step:Tweezers$4.99
-
Feed through opening using tweezers to grasp the wire and carefully pull through.
-
-
-
-
Use the soldering iron to solder new wires to mother board. CAUTION: Soldering iron may get hot and cause minor burns if handled improperly.
-
Use this guide for how to solder: https://www.youtube.com/watch?v=QKbJxytE...
-
-
-
Reattach the battery and test for power by turning on the drone and look for the 4 LEDs turn on.
-
Ask FixBot
All Done!
Cancel: I did not complete this guide.
One other person completed this guide.
Team
USF Tampa, Team S2-G1, Passmore Fall 2017 Member of USF Tampa, Team S2-G1, Passmore Fall 2017
USFT-PASSMORE-F17S2G1
4 Members
36 Guides authored
3 Guide Comments
Great explanation. Just wondering where to get the replacement piece. My drone has the black wire hanging by a single strand just outside the white connector. The red wire is in tact but I would need the whole part that attaches to the board and extends outside the drone to connect the battery to. Thanks
Was wondering i think its charging the blue light flashes when plugged in but wont turn on. Wires look brand new
I’m wondering the same thing, mine lights up blue when charging, wires look good but still no action.
