Introduction
This guide shows how to remove the blade guard on the Protocol Dronium Two. The only tool you will need is the #0 Phillips screwdriver. The screwdriver is also included in the box of your drone. Perform this repair in a clean and well lit area so that you don't lose the screw.
What you need
-
-
-
-
While holding the drone with one hand, gently lift the blade guard straight up and remove it.
-
Ask FixBot
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Team
Arkansas State University, Team 1-2, Chamberlain Spring 2017 Member of Arkansas State University, Team 1-2, Chamberlain Spring 2017
ARSU-CHAMBERLAIN-S17S1G2
4 Members
60 Guides authored
