Fix Your Stuff Community Store

Free Shipping on Domestic Orders $75+

ProScan PLT7223G Battery Replacement

Introduction

If your device will not turn on at all, use this guide to replace your dead or dying battery and make your device functional again.

What you need

  1. ProScan PLT7223G Battery Replacement, Battery: step 1, image 1 of 1

    • Remove both 4 mm screws on the top of the tablet with a PH00 screw driver.

    Edit

  2. ProScan PLT7223G Battery Replacement: step 2, image 1 of 1

    • Use the blue plastic opening tool to pry open the tablet.

    • You will hear popping sounds. That's okay.

    • Be careful when using the blue plastic opening tool on the side of the device near the speakers, as there is a wire here that connects the speakers to the motherboard.

    Edit

  4. ProScan PLT7223G Battery Replacement: step 3, image 1 of 1
    Tool used on this step:
    Tweezers
    $4.99
    Buy

    • Use a soldering tool and tweezers to remove the black and red wire from the motherboard.

    • Be sure to pay attention to where each wire goes so that you attach them in the correct order when reassembling the device.

    • Soldering tool will get hot, handle with care.

    Edit

  5. ProScan PLT7223G Battery Replacement: step 4, image 1 of 1

    • Use a spudger to remove the black tape from the battery.

    Edit

  6. ProScan PLT7223G Battery Replacement: step 5, image 1 of 1

    • Using the flat end of a spudger, carefully separate the battery from the base of the device.

    • There is an adhesive holding the charger in place.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

3 other people completed this guide.

2 Guide Comments

what is the number of the replacement battery??

florcomm - Reply Share

How will I know if my proscan tablet battery is no good once I remove it

Genica Harmon - Reply Share

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 5

Past 30 Days: 16

All Time: 4,589