PowerA Spectra Contoller Bumper Replacement
Mallorie Barton and 2 other contributors
Last updated on Jan 6, 2025
Views: 464
View statistics:
- Past 24 Hours:
- 0
- Past 7 Days:
- 12
- Past 30 Days:
- 68
- All Time:
- 464
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 0 1
No one has marked this guide "completed." Will you be the first?
1 person has marked this guide "completed." It's you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Introduction
Go to step 1 ↓This guide informs you on the proper way to remove the bumper buttons on the PowerA Spectra Controller.
The bumper buttons are two identical buttons located on top of the controller directly across from each other. These buttons may have to be replaced due to worn out springs or joints.
Make sure to disconnect any electrical connections before maintenance.
What you need
Tools
-
-
-
Use a Phillips #2 screwdriver to remove the eight 7.8 mm screws that secure the rear case.
-
-
-
-
Remove the two 7.8 mm screws from the motherboard with a Phillips screwdriver.
-
-
-
Grasp the front plate and motherboard and slowly pull apart to access the bumpers.
-
-
-
Ask FixBot
To reassemble your device, follow the above steps in reverse order.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.
Team
University of North Texas, Team 2-1, Coppersmith Fall 2024 Member of University of North Texas, Team 2-1, Coppersmith Fall 2024
UNT-COPPERSMITH-F24S2G1
4 Members
48 Guides authored
