Oreck XL Upright Vacuum Belt Replacement

Free Shipping on Domestic Orders $75+

Introduction

Over time, vacuum belts can stretch or break, causing the brush roll to stop spinning- even though the vacuum still powers on. This can lead to reduced suction and poor debris pickup. If your Oreck XL Upright Vacuum isn't cleaning effectively, this guide will walk you through checking and replacing the belt to restore performance.

Before you begin the replacement, ensure the vacuum is powered off and unplugged.

What you need

Step 1 Belt

Oreck XL Upright Vacuum Belt Replacement, Belt: step 1, image 1 of 2

Oreck XL Upright Vacuum Belt Replacement, Belt: step 1, image 2 of 2

Using a Phillips-head screwdriver, remove the five screws from the bottom cover.

Edit

Step 2

Lift the bottom cover off of the vacuum.

Edit

Step 3

Oreck XL Upright Vacuum Belt Replacement: step 3, image 3 of 3

Caution: The area around the roller is a pinch point. Be aware of your fingers at all times so you don't get caught or pinched.
Remove the belt from the roller.
The roller is connected to the brush at the front of the vacuum.
Slowly pull the belt off. If you have difficulty, spin the roller as you remove the belt.

Edit

Step 4

Pull the other side of the belt off of the motor shaft.
There is a small opening between the motor shaft and the side of the vacuum. The belt comes out here.
Discard the old belt.