Ordro HDV-D395 Lens Replacement
Nathan Mcintyre and 3 other contributors
Last updated on Dec 19, 2018
Views: 684
View statistics:
- Past 24 Hours:
- 2
- Past 7 Days:
- 9
- Past 30 Days:
- 67
- All Time:
- 684
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 0 1
No one has marked this guide "completed." Will you be the first?
1 person has marked this guide "completed." It's you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Introduction
Go to step 1 ↓This guide would be useful in the event of a broken, scratched, or cracked lens.
What you need
Tools
-
-
-
Pull the slider labeled open, on the bottom right, to unlock the battery.
Ask FixBot
-
-
-
Remove the three screws (length 7.7 mm) from the bottom of the outer case using a JIS000 screwdriver.
-
-
-
Remove plastic casing hiding screws from the strap side of the casing.
-
Unscrew the three screws (length 4.75 mm) using a PH000 screwdriver.
-
Unscrew the two screws (length 6.4 mm) using a JIS000 screwdriver.
-
-
-
Unscrew the four screws (2.9 mm length) from the screen side of the casing using a JIS000 screwdriver.
-
-
-
Remove both side casings by gripping the sides with your hands and pulling gently.
-
-
-
-
Unscrew the seven screws (length 4.22 mm) from the motherboard using a PH000 screwdriver.
-
Pull out or desolder all connected cords from motherboard.
-
-
-
Remove top of the casing to reveal the screws on lens.
-
Unscrew the four screws (size 4.90 mm) using a PH00 screwdriver.
-
-
To reassemble your device, follow these instructions in reverse order.
Team
IUPUI, Team S1-G3, Baechle Fall 2018 Member of IUPUI, Team S1-G3, Baechle Fall 2018
IUPUI-BAECHLE-F18S1G3
3 Members
36 Guides authored
