Nokero SunRay Pro Power Panel USB Assembly Replacement
Nicholas Orr and 4 other contributors
Last updated on Jun 18, 2015
Views: 698
View statistics:
- Past 24 Hours:
- 3
- Past 7 Days:
- 23
- Past 30 Days:
- 98
- All Time:
- 698
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 1 2
1 person has marked this guide "completed." Will you be next?
2 people have marked this guide "completed." Including you — great job!
Favorites: 1 2
1 person has favorited (and subscribed to) this guide. Will you be next?
2 people have favorited (and subscribed to) this guide — including you!
Introduction
Go to step 1 ↓If you are having trouble with the USB port or solar panel, then these steps should be used to replace it altogether.
What you need
Tools
-
-
-
Turn over the device so that the back of the device is facing up.
Ask FixBot
-
-
-
Insert the first plastic opening tool along the side to pry open the case.
-
Use a second plastic opening tool to help separate the remaining seams.
-
-
-
-
Pull the back case off by applying steady pressure to remove it from the adhesive foam tape.
-
-
-
Use the Phillips precision screwdriver to unscrew the two 5.0 mm Phillips screws from the circuit board.
-
Remove the solar panel and circuit board from the front case.
-
-
-
-
-
Solder the two contact points identified by the "S+" and "S-" to disconnect the USB assembly.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
