Ninja NJ600 Fan Replacement
Ryan Heller and 4 other contributors
Last updated on Jun 24, 2015
Views: 1.9K
View statistics:
- Past 24 Hours:
- 2
- Past 7 Days:
- 14
- Past 30 Days:
- 111
- All Time:
- 1,914
Comments: 2
2 comments on steps.
Completed: 0 1
No one has marked this guide "completed." Will you be the first?
1 person has marked this guide "completed." It's you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Action Shots
Be an action hero! This guide needs images that better demonstrate how to perform specific actions.
Introduction
Go to step 1 ↓This guide will illustrate how to disassemble and replace the fan inside your blender.
What you need
Parts
-
-
-
Remove the five screws (13mm long, 6mm head diameter) using a Phillips #2 screwdriver.
Ask FixBot
-
-
-
Without removing any screws, you can pull the 2nd layer free from the base. Do this now and set it down gently next to the base.
-
The power cord runs through a hole in the side of this layer. Squeeze the cord and pull it through the hole to separate the layer from the cord.
-
-
-
Using the Phillips #2 screwdriver, remove these six screws (13mm long, 6mm head diameter). Then carefully remove this layer, and rest it next to the blender base.
-
-
-
-
-
Hold the fan steady and use a wrench or pliers to remove the nut in the image.
-
-
-
To reassemble your device, follow these instructions in reverse order.
Team
Cal Poly, Team 24-2, Lancaster Spring 2015 Member of Cal Poly, Team 24-2, Lancaster Spring 2015
CPSU-LANCASTER-S15S24G2
4 Members
72 Guides authored
