Ninja Mega Kitchen System BL770 Circuit Base Replacement
Tommee Walker and one other contributor
Last updated on Dec 14, 2017
Views: 2.3K
View statistics:
- Past 24 Hours:
- 2
- Past 7 Days:
- 31
- Past 30 Days:
- 106
- All Time:
- 2,328
Comments: 7
6 comments on steps, 1 guide comment.
Go to guide commentsCompleted: 1 2
1 person has marked this guide "completed." Will you be next?
2 people have marked this guide "completed." Including you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Introduction
Go to step 1 ↓This will work as a prerequisite guide for all other guides. This helps us break down the device into the main base layer.
What you need
Tools
-
-
-
Remove the five screws (13mm long, 6mm head) attaching the Base Cover using a Phillips screwdriver (Ph2).
-
Remove the two screws (13 mm long, 6mm head) attaching the Base Cover using a T10 screwdriver.
Ask FixBot
-
-
-
Carefully remove the second layer from the base. You will not need a screwdriver for this step.
-
-
-
-
Remove the 2 screws (13mm, 6mm head) connected to the plastic piece holding down the power cord.
-
Then remove the additional 4 screws (13mm, 6mm head) and 2 screws (11mm, 5mm head) securing the base.
-
Carefully lift the base up from the rest of the blender.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
Arkansas State University, Team S1-G4, Chamberlain Fall 2017 Member of Arkansas State University, Team S1-G4, Chamberlain Fall 2017
ARSU-CHAMBERLAIN-F17S1G4
2 Members
72 Guides authored
1 Guide Comment
Hey Tommee where can I get a circuit board for the ninja bl 773.
