Nikon COOLPIX P2 Motherboard Replacement
Joshua Avery and 4 other contributors
Last updated on Jul 7, 2020
Views: 1.7K
View statistics:
- Past 24 Hours:
- 1
- Past 7 Days:
- 9
- Past 30 Days:
- 33
- All Time:
- 1,732
Comments: 1
1 comment on steps.
Completed: 0 1
No one has marked this guide "completed." Will you be the first?
1 person has marked this guide "completed." It's you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Action Shots
Be an action hero! This guide needs images that better demonstrate how to perform specific actions.
What you need
Tools
-
-
-
Remove the screw located near the speaker port using a Phillips 00 screwdriver.
Ask FixBot
-
-
-
Turn camera upside down so that the battery compartment is facing you.
-
Remove all four screws from the bottom of the camera with a Phillips 00 screwdriver.
-
-
-
Rotate the camera to the opposite side where the A/V outlet is located.
-
Unscrew and remove all four screws with a Phillips 00 screwdriver.
-
-
-
Turn the camera so that the Wi-Fi adapter is facing you.
-
Unscrew and remove all four screws with a Phillips 00 screwdriver.
-
-
-
Using a plastic opening tool, pry the front casing of the camera.
-
Continue this motion all around the front casing of the camera.
-
Gently pull apart the front casing from the rest of the camera.
-
-
-
Carefully pull apart the back casing of the camera from the front of the camera without tearing the orange ribbon.
-
-
-
Pull down the on the black latch to carefully separate the orange ribbon from the motherboard.
-
Pull apart the orange ribbon and front casing from the rest of the camera.
-
-
-
-
-
Use plastic opening tool to carefully pry the LCD Screen from the camera.
-
-
-
Gently pull the ribbon cable down to release the latch, then pull up to remove it from the motherboard.
-
-
-
-
-
-
Continue removing screws from the outside of the camera body.
-
Next pull the plastic side panel off of the camera body.
-
-
-
Remove the two screws connecting the strap loop to the camera body.
-
Remove the three screws from the left side of the camera body.
-
Remove the screw by the shutter button.
-
-
-
Remove the five screws connecting motherboard to the camera body.
-
Carefully detach the two ribbon cables from the motherboard by releasing the black plastic catch, then pull the cables gently upwards out of the connector.
-
-
To reassemble your device, follow these instructions in reverse order.
Team
Cal Poly, Team 3-28, Amido Winter 2012 Member of Cal Poly, Team 3-28, Amido Winter 2012
CPSU-AMIDO-W12S3G28
4 Members
60 Guides authored
