NeuTab N7 Pro Camera Replacement
Robsander Carrasquero and 3 other contributors
Last updated on May 7, 2024
Views: 683
View statistics:
- Past 24 Hours:
- 2
- Past 7 Days:
- 19
- Past 30 Days:
- 100
- All Time:
- 683
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 1 2
1 person has marked this guide "completed." Will you be next?
2 people have marked this guide "completed." Including you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Introduction
Go to step 1 ↓The Neutab N7 Pro has a dual camera. The gadget comes with a back camera of 2 MP and a front camera of 0.3 MP. The Neutab N7 camera can sometimes break or malfunction, and must then be replaced to continue to be able to take pictures and video. Use this guide to replace the camera.
What you need
-
-
-
Insert plastic opening tool and pry back case away, slowly moving the plastic opening tool along the device.
Ask FixBot
-
-
-
Locate the camera unit and note where it is attached to the motherboard.
-
Use a black nylon spudger to remove the adhesive holding it onto to the motherboard.
-
-
-
Tool used on this step:Tweezers$4.99
-
Use a black nylon spudger or tweezers to release the connector holding the camera ribbon cable in place.
-
Carefully pull the ribbon cable out, removing the camera from the motherboard.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
USF Tampa, Team 7-1, Cheng Spring 2016 Member of USF Tampa, Team 7-1, Cheng Spring 2016
USFT-CHENG-S16S7G1
3 Members
60 Guides authored
