Motorola Edge Plus 2022 Daughterboard Replacement

Press and hold the power button for 7 seconds.

Insert a paperclip or SIM card ejector into the small hole located at the bottom of phone.

Gently push to release and remove the SIM card.

Use an iOpener, heat gun, or hairdryer to gently heat the perimeter of the phone.

Insert and slide the iFixit opening pick around heated edges to sever the adhesive securing the rear cover.

Gently remove the back cover using the suction handle or your bare hands.

While applying light pressure, remove the camera bezel cover by sliding the jimmy along the edges.

Use a Phillips #00 screwdriver to remove the eleven 1.5 mm black screws.

Remove the logic board by lifting gently with the flat end of the spudger.

Use the flat end of a spudger to to pry up and disconnect the two press connectors on either side of the battery.

Located in the bottom left corner of the battery, remove the tape (black in the image) with a spudger.

Gently lift the battery up using the black spudger and remove.

Use a Phillips #00 screwdriver to remove the seven 5 mm screws securing the motherboard.

Gently lift and remove the daughterboard cover.

Insert the flat end of the spudger under each of the three press connectors and gently pry them up to disconnect them.

Disconnect the three coaxial connectors (black, white, and blue) with tweezers by pulling them straight up.

Use a Phillips #00 screwdriver to remove the two 1.5 mm silver screws securing the daughterboard and charging port.

Insert the flat end of the spudger under the daughterboard piece and lift it gently to remove it.