Introduction
This guide will walk you through the process of replacing the rear axle in a Maisto Rock Crawler.
What you need
-
-
Flip the R/C truck over.
-
To take off the R/C truck top, use the driver and bit PH2 and remove the four 7.7 mm Phillips screws highlighted.
Ask FixBot
-
-
-
Half way remove the truck top so you can unhinge the antenna from the clips.
-
Remove the R/C truck top completely.
-
-
-
Use the Driver and bit J1 to remove the top under-body plate by unscrewing the eight 9.5 mm Phillips screws.
-
-
-
-
After removing the plate use the driver and bit J1 to unscrew the two 9.5 mm Phillips screws that hold the side circuit board in.
-
-
-
Flip the R/C truck over and remove the four 10 mm bottom under-body plate screws using the driver and bit PH2.
-
-
-
You can refer to the tire replacement guide to keep salvageable tires from the removed axle.
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
USF Tampa, Team 1-2, Sullivan Spring 2016 Member of USF Tampa, Team 1-2, Sullivan Spring 2016
USFT-SULLIVAN-S16S1G2
3 Members
6 Guides authored
