Introduction
If your Logitech Zone Vibe 100 is having difficulties with the microphone, or you are having a hard time being heard for audio reasons- be sure to follow this guide.
This guide requires soldering. If you're unfamiliar with soldering, review the How to Solder and Desolder Connections guide and take appropriate precautions before beginning.
What you need
-
-
-
Pry open both the right earpad and left earpad carefully with your hands.
Ask FixBot
-
-
-
-
-
On the left speaker housing, remove the four 4.5 mm screws with a T3 Torx screwdriver.
-
Remove the single 3.3 mm Phillips #00 screw.
-
-
-
-
Remove plastic cover from the microphone hinge with your hands and clean any debris with a microfiber cloth.
-
-
To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.
Team
UMass Dartmouth, Team 2-8, Botvin Spring 2025 Member of UMass Dartmouth, Team 2-8, Botvin Spring 2025
UMASSD-BOTVIN-S25S2G8
3 Members
48 Guides authored
1 Guide Comment
This is not a good guide, it does not suggest removing the boom assembly or mention where the rubber stop is placed.
