Introduction
The cord assembly is an important part of your controller. Your cord may become bent or damaged over time and need to be replaced.
Make sure to remove your device from power before starting.
What you need
-
-
-
Unscrew the six 2 mm screws at the base.
-
Pull the base cover off with the suction handle
-
Unsolder the cords from the circuit board
Ask FixBot
-
-
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
Team
University of North Texas, Team S1-G3, Friess Fall 2019 Member of University of North Texas, Team S1-G3, Friess Fall 2019
UNT-FRIESS-F19S1G3
3 Members
240 Guides authored
