Introduction
Use this guide to replace a broken LED bulb in a Light Angel motion activated LED. Disassembling the device requires a Phillips screwdriver and a plastic opening tool. Replacing the LED bulb requires knowledge of soldering. For users with basic soldering experience, this project will take about 30 minutes.
What you need
-
-
-
Using a plastic opening tool, remove the base of the Light Angel.
Ask FixBot
-
-
-
Using a Phillips head jeweler's screwdriver, remove the screw on the battery housing.
-
-
-
-
Using a Phillips head jeweler's screwdriver, remove the (6) screws holding the LED housing together.
-
-
-
Insert the plastic opening tool into the crease on the side of the LED housing to separate it from the rest of the device.
-
-
-
Locate the faulty light emitting diode on the back of the circuit board.
-
Using a soldering iron and desoldering braid, unsolder the connection on the light emitting diode.
-
-
-
Insert the new light emitting diode through the two holes left from removing the old one.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Team
Colorado Springs, Team 8-6, Mcmichael Spring 2016 Member of Colorado Springs, Team 8-6, Mcmichael Spring 2016
UCCS-MCMICHAEL-S16S8G6
3 Members
12 Guides authored
