Introduction
Before starting this guide, you should have a way to prevent the loss of small screws.
What you need
-
-
-
Use a plastic iFixit opening tool to pry the edges of the back case loose by placing it in between the edge of the cover and the screen.
-
-
-
Use the spudger to reach into the center of the device and pry off the back case by giving it a light force upwards.
-
-
-
-
-
Use the spudger to disconnect the camera and battery from the printed circuit board by putting the spudger in between the connections and the printed circuit board and pushing the spudger up.
-
-
Tool used on this step:Tweezers$4.99
-
Use the nylon tip tweezers to push the camera out from between the power button and the kickstand.
-
-
-
-
Use the tweezers to lift the black tape from the corner of the printed circuit board.
-
Ask FixBot
To reassemble your device, follow these instructions in reverse order.
Team
Cal Poly, Team S2-G6, White Winter 2019 Member of Cal Poly, Team S2-G6, White Winter 2019
CPSU-WHITE-W19S2G6
4 Members
84 Guides authored
