Introduction
Instructions to get to and remove the keypad unit.
What you need
-
-
Orient the phone as shown.
-
Remove the battery cover by pushing upward with your thumb.
-
-
-
Place your fingernail at the top of the battery and pry the battery out towards you.
-
-
-
Orient the phone as shown with the battery already removed.
-
-
-
-
Remove the 2 plastic plugs located on the side and upper quadrant of the rear body panel by using the push-pin and lifting outwards.
-
Use a Phillips #00 screwdriver to remove the 5 screws as shown here.
-
-
-
Place an iPod opener tool in the seam above the antenna.
-
Run the tool around the perimeter of the entire phone.
-
-
-
Locate the tabs that hold the logic board in place.
-
Pull the outer frame of the phone outwards to release the board from the tabs.
-
-
-
Locate the copper connection (orange-colored) on the back of the board.
-
Pry the connector free from the board with your fingernail.
-
Ask FixBot
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
Cal Poly, Team 4-13, Forte Winter 2010 Member of Cal Poly, Team 4-13, Forte Winter 2010
CPSU-FORTE-W10S4G13
5 Members
25 Guides authored
