Introduction
Use this guide to replace the vibration motor on your LG G3 Vigor.
What you need
-
-
Remove the battery by lifting from the slot at the bottom of the battery.
-
-
-
Remove the twelve Phillips #00 screws securing the midframe to the rest of the phone.
-
-
-
-
Work a plastic opening tool around the perimeter of the phone to separate the midframe from the rest of the phone.
-
-
-
Use the spudger to gently unplug the ribbon cable connected to the motherboard. Then remove the rear facing camera.
-
-
-
Use the spudger to gently unplug the ribbon cable connected to the motherboard.
-
Remove the front camera.
-
-
-
Use the flat edge of a spudger to disconnect the motherboard ribbon connector.
-
-
-
Use the pointed end of a spudger to push back the two motherboard retaining flaps.
-
The motherboard should now be able to be lifted out of the device.
-
Ask FixBot
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
