Introduction
In addition to protecting the internal components of the watch, the back case also fastens the power charging conductor and heart rate monitor to the watch's motherboard.
What you need
-
-
-
Place the watch upside down on a hard surface so that its back case is facing upright.
-
Use a T4 Torx Star screwdriver to remove the four 4.0 mm Torx screws from the corners of the back case.
Ask FixBot
-
-
-
-
Use a plastic opening tool to pry open the back case from both sides of the watch.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
USF Tampa, Team 1-1, Remmell Fall 2015 Member of USF Tampa, Team 1-1, Remmell Fall 2015
USFT-REMMELL-F15S1G1
5 Members
126 Guides authored
