Introduction
If you are worried about oil or grease leaking inside or out of your mixer, you might have to replace your gasket. This guide will show you how to do this.
What you need
-
-
-
Using a 4 mm pin punch and hammer, hammer the pin until it is dislodged from the planetary gear cover.
-
-
-
Using a flathead screwdriver, remove the five 28 mm front motor housing screws.
-
Using the same flathead screwdriver, remove the two 28 mm locking screws.
-
-
-
-
Turn your device around. Using the same flathead screwdriver, remove the two 28 mm rear locking screws.
-
-
-
Using a Phillips #2 screwdriver, remove the 10 mm screw from top of back cover.
-
-
-
-
Use a butter knife or putty knife to remove grease from around the gasket.
-
Place grease in motor housing cover.
-
-
Ask FixBot
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
9 other people completed this guide.
Team
Cal Poly, Team 14-28, Maness Fall 2014 Member of Cal Poly, Team 14-28, Maness Fall 2014
CPSU-MANESS-F14S14G28
4 Members
72 Guides authored
2 Guide Comments
I got all the way to the last step of replacing the pin when i notice the mixer seemed to lock there in place and not move. What did i do wrong?
Dawn dawn6463@yahoo.com
