Introduction
Replacing the Water Filter requires only a couple steps as outlined below.
What you need
-
-
-
Remove the Water Reservoir Cap and the Water Reservoir from the brewer by simply pulling up and out
Ask FixBot
-
-
-
-
Remove the three 9.5 mm Phillips #1 screws that secure the small circular screen to the bottom of the water reservoir.
-
-
-
This circular screen has a rubber "O"-ring around the base. Use the plastic opening tool to pry off the rubber seal. Replace with undamaged seal.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Team
Cal Poly, Team 1-7, Maness Spring 2016 Member of Cal Poly, Team 1-7, Maness Spring 2016
CPSU-MANESS-S16S1G7
5 Members
30 Guides authored
