Introduction
When the machine is open, replacing the brewing unit is quite easy. Actually, you just need to take out the panel under the water tank, but it's a little easier if you open the machine completely using this guide.
What you need
-
-
Tool used on this step:iFixit Precision 4 mm Screwdriver Bit$2.99
-
Position the machine with the water tank side facing you.
-
The panel covering the brew group is fixed at the top edge with two oval head screws.
-
Remove the two oval head screws and lift the panel out.
-
There it is: the brewing unit.
Ask FixBot
-
-
-
The photo is from a Jura J5, but the brewing unit is basically the same and you can easily see how the brewing unit is attached:
-
Two Torx T20 screws with fine thread
-
One Torx T15 screw
-
The hot water inlet is plugged in.
-
The hose with the coffee spout is plugged on top.
-
-
-
-
Unscrew the two Torx T15 machine screws.
-
Unscrew the Torx T15 screw at the bottom of the hot water inlet.
-
Pull the brewing unit out to you. The hose to the coffee spout is still attached at the top.
-
Pull off the hose to the coffee spout.
-
-
-
Start now with the replacement or revision of the brewing unit.
-
If you want to disassemble the brewing unit for cleaning and installing new seals, follow this or this guides.
-
There is one small difference with this brewing group: the drainage valve is fitted with a cover, but this is easy to remove. Unscrew the two Torx T8 screws.
-
Use these instructions to overhaul the drainage valve.
-
-
Work through the steps in reverse order to reassemble your device.
Special thanks to these translators:
100%
These translators are helping us fix the world! Want to contribute?
Start translating ›
