Introduction
Use this guide if your Huawei Union will not charge when plugged into a charger or begins losing charge faster than previously observed.
What you need
-
-
Wedge your thumb nail, or the flat end of a spudger, into the bottom left corner and pry off.
Ask FixBot
-
-
-
Use the flat end of a spudger, or fingernail, to lift up the battery and pull out.
-
-
-
Remove the thirteen 3mm Phillips #00 screws from the back panel.
-
-
-
-
Firmly hold the second ribbon cable's plastic film cover and pull up to disconnect.
-
-
-
Wedge the flat end of a spudger underneath the motherboard and pry upwards to separate it from the frame.
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
USF Tampa, Team S1-G1, Nance Spring 2018 Member of USF Tampa, Team S1-G1, Nance Spring 2018
USFT-NANCE-S18S1G1
4 Members
12 Guides authored
