Introduction
After using this guide you will have learned how to replace the rotor to your blender. You will need to use basic tools to complete this guide.
What you need
-
-
-
Remove the container from the blender.
-
Hold the blender and the container, then twist the container in a clockwise motion.
Ask FixBot
-
-
-
Turn the blender so the bottom is facing you.
-
Using a Phillips #2 screwdriver, remove the two 5 mm Phillips screws from the base.
-
-
-
-
Using a Phillips #2 screwdriver, remove the two 5 mm Phillips screws from the motor platform.
-
-
-
Using a spudger, carefully insert the tip into the coil of wire around motor.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
USF Tampa, Team 2-5, Sullivan Fall 2015 Member of USF Tampa, Team 2-5, Sullivan Fall 2015
USFT-SULLIVAN-F15S2G5
4 Members
60 Guides authored
3 Guide Comments
Hi, Any idea where to get a new rotor.
Hey! did you got the rotor?
Cómo puedo retirar la pieza blanca del rotor,si está bien socada , apretado,como detengo el rotor no de vuelta gracias
