Introduction
Use this guide to remove the display assembly of the HP Chromebook 11 G3.
What you need
-
-
Flip the laptop upside down so that the lid lies flat on the table.
-
Remove the nine 6mm Phillips #00 screws that line the border.
Ask FixBot
-
-
Tool used on this step:Tweezers$4.99
-
Remove the two rubber feet closest to the hinge using tweezers.
-
Remove the two 6mm Phillips #00 screws revealed under these rubber feet.
-
-
-
Flip the laptop so it is in the upright position.
-
Open the lid.
-
Unsnap the keyboard mount along the border of the laptop using a plastic opening tool.
-
-
-
Tilt the keyboard mount up.
-
Use a spudger to flip up the two ZIF connector retaining flaps for the ribbon cables that connect the keyboard mount to the motherboard.
-
Gently remove both ribbon cables.
-
-
-
-
Gently tug on the black and white wires connected to the Wi-Fi module to disconnect them.
-
-
-
Using a spudger, lift the ZIF retaining flap that secures the display’s ribbon cable to the motherboard.
-
Gently pull the ribbon cable out of its socket.
-
-
-
Remove the two 6mm Phillips #00 screws located near the upper left and right corners of the hinge mounts.
-
-
-
Rotate the lid to a 90-degree angle with the table.
-
Shimmy the lid out of the laptop.
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
Cal Poly, Team S23-G3, Livingston Spring 2017 Member of Cal Poly, Team S23-G3, Livingston Spring 2017
CPSU-LIVINGSTON-S17S23G3
4 Members
12 Guides authored
