Skip to main content

Free Shipping on Domestic Orders $75+

HP 15-ay052nr Bottom Cover Replacement

What you need

    1. HP 15-ay052nr Bottom Cover Replacement, Battery: step 1, image 1 of 1
      • To protect the device and yourself, make sure your device is completely powered down before disassembling. Disconnect all external devices before starting any tear down process.

      • Turn the device and lay it upside-down on a flat surface so the base of the computer is facing upwards.

      Ask FixBot

      Add Comment

    2. HP 15-ay052nr Bottom Cover Replacement: step 2, image 1 of 1
      • Identify the two (2) sliding lock mechanisms on either side of the battery and slide them towards the center.

      • The sliders are located at the back of the device on the side where the display hinges are.

      • The slider closest to the optical drive (CD reader) clicks open but the opposite slider has a spring.

      Ask FixBot

      Add Comment

    3. HP 15-ay052nr Bottom Cover Replacement: step 3, image 1 of 1
      • Pull the battery slightly up and out to remove.

      • If the battery doesn't pop out, the sliders weren't pushed in far enough. Push the sliders towards the center until the battery pops out.

      Ask FixBot

      Add Comment

    1. HP 15-ay052nr Bottom Cover Replacement, Bottom Cover: step 4, image 1 of 1
      • Remove the rubber feet on the bottom of the device to access all the screws.

      • There are two rubber feet, one on each side of the battery compartment.

      Ask FixBot

      Add Comment

    2. HP 15-ay052nr Bottom Cover Replacement: step 5, image 1 of 1
      • Unscrew the twelve 9 mm JIS #0 screws on the back of the device.

      • Gently remove the optical drive (CD reader) to more easily separate the base.

      Ask FixBot

      Add Comment

    3. HP 15-ay052nr Bottom Cover Replacement: step 6, image 1 of 1
      • Unclip the keyboard surface from the base using an iFixit opening tool around the entire border.

      Ask FixBot

      Add Comment

    4. HP 15-ay052nr Bottom Cover Replacement: step 7, image 1 of 1
      • Separate the base of the computer from the component assembly.

      • The optical drive can be placed in the base where it corresponds to prevent misplacing it.

      Ask FixBot

      Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

2 other people completed this guide.

0 Guide Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 8

Past 30 Days: 40

All Time: 941