George Foreman GR-20 Disassembly
Aidan Admadjaja and 4 other contributors
Last updated on Dec 21, 2021
Views: 2.1K
View statistics:
- Past 24 Hours:
- 3
- Past 7 Days:
- 15
- Past 30 Days:
- 77
- All Time:
- 2,061
Comments: 2
2 guide comments.
Go to guide commentsCompleted: 2 3
2 people have marked this guide "completed." Will you be next?
3 people have marked this guide "completed." Including you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Introduction
Go to step 1 ↓If your George Foreman GR-20 (model GR20WHT) has ceased to function properly, then disassembling it is the first step towards diagnosing and fixing your GR-20. Use this guide to walk you through step by step how to completely disassemble your George Foreman GR-20. Before beginning the disassembly process, check to make sure the device is disconnected from any external power source and cool to the touch. Following the necessary safety precautions is important when disassembling. Follow the steps in reverse order for reassembly of your George Foreman GR-20.
What you need
Tools
-
-
-
Open the grill and remove the two Phillips #2 screws from the top lid.
Ask FixBot
-
-
-
Using a pick, peel off the model number sticker to expose the two screws underneath. Remove these screws using a Phillips #2 screwdriver.
-
-
-
Remove the Phillips #2 screw from the orange tab.
-
Detach the top lid from the bottom of the grill.
-
-
-
To measure the resistance of the heating coil, disconnect the blue wire from the heating element.
-
-
-
-
To access the underside of the grill, flip the grill over and remove the rubber bottoms of the two front feet to expose the screws.
-
-
-
To remove the power cord from the device, remove the two Phillips #2 screws keeping the power cord and the blue and white wires connected.
-
-
-
After removing the screws, slide the blue and white wires out through the gap.
-
-
-
Remove the two Phillips #2 screws attaching the fuse to the grill.
-
Remove the fuse from the grill.
-
-
-
Remove the Phillips #2 screw from the white wire.
-
Remove the white wire from the grill.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Team
Tufts University School of Engineering, Team S1-G2, Bell Fall 2020 Member of Tufts University School of Engineering, Team S1-G2, Bell Fall 2020
TUFTS-BELL-F20S1G2
2 Members
12 Guides authored
