Introduction
If the front screen is faulty in the Garmin DriveSmart 50 LMTHD, this guide will provide step by step instructions on how to remove and replace it. Before beginning the repair make sure to power off and unplug the device to avoid electrical hazards. If the front screen is cracked, wear safety glasses and gloves to prevent splinters or any type of injury.
Check out our troubleshooting page to confirm that the screen is the underlying cause of the problem.
What you need
-
-
-
Remove the four 5 mm screws from the back of the device using a T4 Torx screwdriver.
Ask FixBot
-
-
-
Use a spudger to gently pry the locks around the screen, applying even pressure along the edges.
-
-
-
-
Carefully open the casing to avoid damaging any fragile components, and gently disconnect the black and red wire plug attached to it.
-
Since the plug is on a hook, unlock it with the spudger tool.
-
-
-
Flip the Garmin over to the other side in the previous step, and slide the screen backwards to undo the orange connector.
-
Use the pointed end of the spudger tool to lift the clasps and detach the orange connector.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Team
University of North Texas, Team 1-3, Rea Fall 2025 Member of University of North Texas, Team 1-3, Rea Fall 2025
UNT-REA-F25S1G3
4 Members
48 Guides authored
