Free Shipping on Domestic Orders $75+

Introduction

Use this guide to replace the 5-inch glass capacitive touchscreen on the Garmin Drive 53 EX. A replacement is typically required for screens that are physically cracked, exhibit visual artifacts, or no longer respond to touch inputs. Always ensure the device is completely powered off before disconnecting the display ribbon cables to prevent electrical damage.

What you need

Step 1 Display

Garmin Drive 53 EX Display Replacement, Display: step 1, image 1 of 2

Garmin Drive 53 EX Display Replacement, Display: step 1, image 2 of 2

Power off the Garmin Drive 53 EX completely to prevent electrical shorts during the repair.
Use a T2 Torx screwdriver to remove all four screws.

Edit

Ask FixBot

Step 2

Insert a plastic opening tool or a thin prying pick into the seam where the front bezel meets the rear housing.
Gently lift the rear casing away from the front assembly, being careful not to strain the internal ribbon cable connecting the screen to the motherboard.

Edit

Ask FixBot

Step 3

Open the ZIF (Zero Insertion Force) connector on the motherboard by flipping up the small locking tab and sliding the screen’s ribbon cable out.
Remove the screen.

Edit

Ask FixBot