GameSir X2s Type-C Face Buttons Replacement
Carlos D Franco and 2 other contributors
Last updated on Jan 16, 2026
Views: 417
View statistics:
- Past 24 Hours:
- 4
- Past 7 Days:
- 13
- Past 30 Days:
- 62
- All Time:
- 417
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 0 1
No one has marked this guide "completed." Will you be the first?
1 person has marked this guide "completed." It's you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Bullets!
Better coordination with markups and the color/type of bullets will help make this guide more clear!
Markup Mishap
This guide needs better markups. Help out by correcting or making some markup annotations.
Scenic Route
This guide's procedure isn't the most efficient way to get the job done, but still may be useful in some circumstances.
Introduction
Go to step 1 ↓This guide explains how to replace the face buttons (A, B, X, Y) on the GameSir X2s Type-C Mobile Gaming Controller.
Face buttons are the primary action inputs used for jumping, attacking, confirming selections, and interacting with games. Replacing faulty face buttons restores reliable input and improves responsiveness during gameplay.
=== ===
What you need
Tools
-
-
-
Use a 000 Phillips screwdriver to remove the following eight silver fine-thread 6mm screws.
-
Flip the controller upright.
Ask FixBot
-
-
-
Remove the four silver fine-thread 4.5mm screws under the rubber grip using the 000 Phillips screwdriver.
-
Flip the GameSir X2s Type-C to the back.
-
Using a prying tool around the lip, where both pieces of plastic meet, run that around the hold device.
-
Pop off the plastic piece attached to the device.
-
-
-
Remove the blue strip connected to the board.
-
Remove six silver fine-thread 4.5mm screws and the two black fine-thread 4.5mm screws using a 000 Phillips screwdriver.
-
Remove the gold strip connected to the board.
-
-
-
Remove the three black fine-thread 4.5mm screws using the 000 Phillips screwdriver.
-
Remove the red and black wires from the board.
-
Remove the board from the GameSir X2s Type-C.
-
-
-
Remove the 3 black fine-thread 4.5mm screws from behind the right trigger using a 000 Phillips screwdriver.
-
Remove the 3 black fine-thread 4.5mm screws from the board using a 000 Phillips screwdriver.
-
Remove the red and black wires from the board.
-
-
-
-
-
-
Remove the face buttons from the GameSir X2s and replace them with new face buttons.
-
-
To reassemble your device, follow these instructions in reverse order.
Team
Purdue University Northwest, Team 4-11, Dieterle Fall 2025 Member of Purdue University Northwest, Team 4-11, Dieterle Fall 2025
PNW-DIETERLE-F25S4G11
5 Members
72 Guides authored
