Eightarc Fusion Headphone Jack Replacement
Christopher and one other contributor
Last updated on Jun 19, 2015
Views: 865
View statistics:
- Past 24 Hours:
- 3
- Past 7 Days:
- 21
- Past 30 Days:
- 81
- All Time:
- 865
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 0 1
No one has marked this guide "completed." Will you be the first?
1 person has marked this guide "completed." It's you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Slice and Dice
The steps in this guide should be split up and made into a series of prerequisite guides.
Introduction
Go to step 1 ↓This guide demonstrates the removal of the headphone jack from the Eightarc Fusion.
Warning: Use caution when placing the joystick face down on the table. The joystick can crack if placed down too hard. Be sure to gently turn the device over and place it face down. It can be helpful to balance the other side of the device to distribute the weight.
What you need
Tools
-
-
-
Place the controller face down (buttons and joystick down).
-
Use a Phillips Head #1 screwdriver to remove the eight 9.65mm screws located on the felt and metal backplate.
Ask FixBot
-
-
-
Open the door for the cord storage compartment on the right side of the device.
-
Reach under the panel and push upwards on the back panel. Lift it up and remove it from the device.
-
-
-
-
Grasp the white plug connecting the wires to the headphone jack, and pull gently upwards.
-
-
-
Using a Phillips head #1 screwdriver, remove the two washer head screws from the headphone jack.
-
-
-
Gently wiggle the headphone jack left and right, pulling it towards you until it slides out of the hole in the enclosure.
-
-
To reassemble your device, follow these instructions in reverse order.
Team
Cal Poly, Team 17-35, Amido Winter 2015 Member of Cal Poly, Team 17-35, Amido Winter 2015
CPSU-AMIDO-W15S17G35
4 Members
60 Guides authored
